My Actifit Report Card: December 29 2023
Making a circular table edge
Dear friends,
Today, I continue to work with my circular table. I needed to make a circular edge so I calculated the circumference with the radius I measured. Radius = 60.3 cm so the circumference = 2Pi x R = 23.1460.3 = 378.87 ~ 379 =149.16 in = 14 ft 1 in. I will need two 1" steel hollow tubes for the edge. And I had to calculate how long the hollow tube I would need for one table. So I drew a sketch in solidworks and noted down the measurement and calculated how many steel hollow tubes I would need. The unit in the following drawing is in inches.
Then, in the afternoon I bought the required materials and started bending a tube in the evening. I used 0.6 inch 1.2mm tick hollow tubes (instead of 1") for reinforcing the table edge. I use my manual bender to bend the steel. It took some time for me because I gradually increase the curvature. Because it was manual, it was like an arm movement exercise for me. The following is my activity record and the result of my work.
I bended one tube first; I will attach It to the table tomorrow. I hope it turn out well.
That's some of my activities I would like to share with you for today. Other time, I did house chores and ran errands for my mother and myself.
@princekham
Myanmar
29th Dec 2023
This report was published via Actifit app (Android | iOS). Check out the original version here on actifit.io
!hiqvote
@princekham, the HiQ Smart Bot has recognized your request (1/2) and will start the voting trail.
In addition, @princekham gets !WEED from @hiq.redaktion.
For further questions, check out https://hiq-hive.com or join our Discord. And don't forget to vote HiQs fucking Witness! 😻
@princekham!
@hiq.smartbot passed you the virtual joint!If you do not want to receive these comments, please reply with !STOP
Nice activities!
!LUV
!PIZZA
!MEME
princekham, asterkame sent you LUV. 🙂 (6/10) tools | trade | connect | daily
Made with LUV by crrdlx.
!pizza